Enter Store
Branch Locations
Information and FAQs
No Credit Card
Bank Deposit Welcome
No Problem, Check
out the Welcome page
for more details
 
Adjust 'a' wings Assembly Instructions

Step 5
Select one adjustment wire, take the end with the
single stopper and thread it through the first adjustment keyhole.
Then thread it back through one of the other adjustment
keyholes, as shown below.
This presets your reflectors width
Step 5
 

Step 6
While holding the opposite end of the adjustment wire
(that has 2 stoppers) carefully bend the wings back
away from their spine and lock the end stopper
into the single keyhold provided. Repeat steps 5 & 6
at the opposite end of the wings to attach the 2nd adjustment wire.
Step 6a
Note: The 2nd stopper on each adjustment
wire is for grip only in these procedures.
Step 6b

Your Adjust-a-wings now look like this


Step 7
Adjusta-a-wings settings are changed by reversing
Step 6 and choosing a different keyhole
position from Step 5.
Note: Adjust one end of the wings at a time.

WARNING

 
For safe operation, ensure that the power
is off before adjusting the wings or lampholder

Step 8

Take the lampholder and the 2 thumb screw

provided and attach as shown below

Step 8a
 
Step 8b